Pre Cut

PC 5000

PC 5000

To remove

Deep scratches

Application with

Polishpad (blue/stable hard)

PC 5000 is a pre-grinding polishing to recondition extremely weathered or damaged paintwork. Owing to the volume and the homogenous abrasive grain, this grinding polishing process ensures quick, optimum sanding to successfully remove deep scratching and abrasion marks from a grain size of P1500.

CTA: With high density of aluminoxid

Zvizzer PC 5000 can be used on all existing paints. Including scratch-resistant, fresh and hardened paint. Thanks to the aluminoxid quality and quantity, dust is reduced to minimum and the polish effectiveness increases.

Water- based polishes

ZviZZer polishing formula is unique. PC5000 is, as the rest of ZviZZer polishing pastes, water based and free . It has been designed to apply with Zvizzer Hard-stable pads (blue) and to protect them and make them last longer. As the water-based polishing paste does not contain solvents, it does not damage the Pads not removes the velcro from the foam.


Advantages PC5000 Pre Cut Scratch Remover

  • Minimum Dust
  • Additional cut due to the high proportion of aluminoxid
  • Speeds up work by 30%
  • Water based
  • Product for professionals
  • Made in Germany

Application

We recommend using the blue polishing pad for this procedure. Apply a sufficient quantity of PC5000 to the paint defect, surface or polishing pad. If you are using a low speed (c. 1,000 rpm) distribute evenly over the defect area, increase the speed to c. 1,800 rpm and polish using a light pressure to finish off.

NOTE: Always use a clean polishing pad to avoid unnecessary damage to surfaces. Safety data sheet is available on request.


Product Filling quantity in ml Art. Nr
PC 5000 Pre Cut 750 ml ZV-PC5000750
PC 5000 Pre Cut 250 ml ZV-PC5000250

Polishing pad (blue/stable hard)

NEW EXCLUSIVELY FOAM FORMULA WORLDWIDE!